3D printed lampshade


Project Description

Produce at the fabrication lab at Ferney Voltaire of Pangloss and based on Sten Dan Poulsen design,

Guillaume Cabrié from LEMANTEK printed a large 3D lampshade using the 3D printer Factory 2.0  in less than 10h.

“using the vase mode, you can espect to produce large custom pieces like lampshade”

These samples were made in ABS & PS.

Source: thingiverse


By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close